|
|
What you get! This set of deathstar panels allows you to create your own deathstar surface base for your favorite star wars model / toy. For best production the panels were cast in four greater panels. |
|
Use a sharp hobby knife and carefully cut out the smaller tiles. |
|
For best performance sand down 0,3 mm from each panels underside. when cleaning the sides of the panles please take care of the correct angle. |
|
A cleaned set contains 20 panels 24mm x 24mm, 3 panels 24mm x 48mm, 1 panel 48mm x 48mm. |
|
|
Now you can have your own property on the Death Star! These authentic Death Star panels were especially made to create a perfect base for your favourite Star Wars model or toy. This is the way your X-Wing model wants to look at the next sci-fi exhibition! Actual pic shows a Fine Molds X-Wing on a Death Star surface base. Please note: you need more than 1 set to create a base of the size shown in the picture. You`re not forced to glue the panels close together (edge-to-edge) to get a nice result. The original Death Star surface have had a lot of vacant areas too. |
|
|
There are some panles on which the "Death Star buildings" are bigger than the floorplate. These should be sanded off if the panels are glued together side by side. Eventually you can use those for the edge of the complete surface |
 |
The set contains a bigger tile shown in the front of the image. This tile was especially created to hold the display mount of your model. when creating your Death Star base you should start with this tile. |
 |
Another special tile is the "vacant - panel" wich was not only create to show a vacant area (huh). You should use this tile to design your own free-style Death Star panel by glueing some greeblies onto it. |
