hangar equipment

	What you get: 15 high quality resin parts to create a nice and active environment around you landed rebel starfighter craft like the 1:72 fine molds x-wing fighter or/and y-wing fighter. this set will also match very nice with the 1:72 star wars 1:72 a-wing fighter or/and fighter b-wing by fatastic platics. the set contains: personnel shuttle with control box and driver, rhodian standing pilot, two R2 units with different heads and a nice gonk droid, 20 ground lights and 5 hangar equipment parts such as power supply, starship diagnostic system and fueling installation.
	Image shows a few built up parts from the set such as starship diagnostic system with monitors applied and completed gonk-droid. I recommend superglue for cementing all parts in this set.
	A few plastic stripes are given to each set to create monitor attachments like shown in the image. you may sand the attachments ends in a particular angle.
	building the grab: cut the end of the smaller plastic stripe in an angle shown in the image.....
	... and glue it to the control box like shown here on the image....
	.... then gently bend the stripe into postion. test fit often before cutting the grab!!! there is a adjustment for the grabs lower end - you will find it!
	gluing the driver into correct position is a bit tricky too but no problem for advanced modeler. all parts should be painted before gluing the driver onto shuttle. you may use double-sided tape to fix the driver temporary for test fitting or later remove.
	finally use tweezers and superglue to glue the grid in a good looking position.
	when building this set I was inspired by the great star wars crossection book as well as the euipment shown in the movies.

Here are some images of the hangar equipment set IN USE ! this great hangar diorama was built by Stafan Hacker from Germany. Stefan used few of the 1:72 hangar equipment sets as well as 1:72 hasegawa ground crew sets in his hangar! enjoy!