interior for millennium falcon

	This shows what you`ll get: a 11 piece resin kit to build new turbolasers for the MPC / ERTL Millenium Falcon. This kit contains very tiny and filigree parts and is suitable for experienced modellers only. I recommend the use of superglue. Before you begin all parts should be cleaned and the flesh should be removed. color of resin may vary.
	Drill small holes into the plates with a tiny drill bit as shown in the picture.
	The fork which will carry the actual turbolaser must be changed a bit also. The small pins that hold it has to become narrower and shorter. The right pin shown in the picture is already in the correct size and shape.
	The turbolaser itself is made from 6 parts. These has to be glued together as shown here in the picture.
	Please be aware that all lasertips are glued straight. Probably it is necessary to sand the flat underside of the lasertips a bit for a proper fit. Please testfit until everything is ok, then testfit once more before you glue everything together.
	Now attach the armour plating to the turbolaser. Be sure that the complete group must fit into the fork! For the correct position take a look at the picture below.
	You must drill a hole into this part as shown which will be used to attach the fork including the gun.
	Now the laser including the armour plating can be attached to the fork. Please be very careful while doing this! First click one side into place, then bend the fork just as much as necessary to let the other side click into place. At last glue the small rectangular piece to the top, and your new and accurate turbolaser for the Millenium Falcon is done!